Vulnerabilities > Linux > Linux Kernel > 6.13
| DATE | CVE | VULNERABILITY TITLE | RISK |
|---|---|---|---|
| 2025-04-16 | CVE-2025-22051 | NULL Pointer Dereference vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: staging: gpib: Fix Oops after disconnect in agilent usb If the agilent usb dongle is disconnected subsequent calls to the driver cause a NULL dereference Oops as the bus_interface is set to NULL on disconnect. This problem was introduced by setting usb_dev from the bus_interface for dev_xxx messages. Previously bus_interface was checked for NULL only in the functions directly calling usb_fill_bulk_urb or usb_control_msg. Check for valid bus_interface on all interface entry points and return -ENODEV if it is NULL. | 5.5 |
| 2025-04-16 | CVE-2025-22052 | NULL Pointer Dereference vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: staging: gpib: Fix Oops after disconnect in ni_usb If the usb dongle is disconnected subsequent calls to the driver cause a NULL dereference Oops as the bus_interface is set to NULL on disconnect. This problem was introduced by setting usb_dev from the bus_interface for dev_xxx messages. Previously bus_interface was checked for NULL only in the the functions directly calling usb_fill_bulk_urb or usb_control_msg. Check for valid bus_interface on all interface entry points and return -ENODEV if it is NULL. | 5.5 |
| 2025-04-16 | CVE-2025-22054 | NULL Pointer Dereference vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: arcnet: Add NULL check in com20020pci_probe() devm_kasprintf() returns NULL when memory allocation fails. | 5.5 |
| 2025-04-16 | CVE-2025-22056 | Out-of-bounds Write vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: netfilter: nft_tunnel: fix geneve_opt type confusion addition When handling multiple NFTA_TUNNEL_KEY_OPTS_GENEVE attributes, the parsing logic should place every geneve_opt structure one by one compactly. | 7.8 |
| 2025-04-16 | CVE-2025-22063 | NULL Pointer Dereference vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: netlabel: Fix NULL pointer exception caused by CALIPSO on IPv4 sockets When calling netlbl_conn_setattr(), addr->sa_family is used to determine the function behavior. | 5.5 |
| 2025-04-08 | CVE-2025-22009 | NULL Pointer Dereference vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: regulator: dummy: force synchronous probing Sometimes I get a NULL pointer dereference at boot time in kobject_get() with the following call stack: anatop_regulator_probe() devm_regulator_register() regulator_register() regulator_resolve_supply() kobject_get() By placing some extra BUG_ON() statements I could verify that this is raised because probing of the 'dummy' regulator driver is not completed ('dummy_regulator_rdev' is still NULL). In the JTAG debugger I can see that dummy_regulator_probe() and anatop_regulator_probe() can be run by different kernel threads (kworker/u4:*). | 5.5 |
| 2025-04-08 | CVE-2025-22010 | Improper Locking vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: RDMA/hns: Fix soft lockup during bt pages loop Driver runs a for-loop when allocating bt pages and mapping them with buffer pages. | 5.5 |
| 2025-04-08 | CVE-2025-22011 | Unspecified vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: ARM: dts: bcm2711: Fix xHCI power-domain During s2idle tests on the Raspberry CM4 the VPU firmware always crashes on xHCI power-domain resume: root@raspberrypi:/sys/power# echo freeze > state [ 70.724347] xhci_suspend finished [ 70.727730] xhci_plat_suspend finished [ 70.755624] bcm2835-power bcm2835-power: Power grafx off [ 70.761127] USB: Set power to 0 [ 74.653040] USB: Failed to set power to 1 (-110) This seems to be caused because of the mixed usage of raspberrypi-power and bcm2835-power at the same time. | 5.5 |
| 2025-04-08 | CVE-2025-22012 | Improper Locking vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: Revert "arm64: dts: qcom: sdm845: Affirm IDR0.CCTW on apps_smmu" There are reports that the pagetable walker cache coherency is not a given across the spectrum of SDM845/850 devices, leading to lock-ups and resets. | 5.5 |
| 2025-04-08 | CVE-2025-22014 | Improper Locking vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: soc: qcom: pdr: Fix the potential deadlock When some client process A call pdr_add_lookup() to add the look up for the service and does schedule locator work, later a process B got a new server packet indicating locator is up and call pdr_locator_new_server() which eventually sets pdr->locator_init_complete to true which process A sees and takes list lock and queries domain list but it will timeout due to deadlock as the response will queued to the same qmi->wq and it is ordered workqueue and process B is not able to complete new server request work due to deadlock on list lock. Fix it by removing the unnecessary list iteration as the list iteration is already being done inside locator work, so avoid it here and just call schedule_work() here. Process A Process B process_scheduled_works() pdr_add_lookup() qmi_data_ready_work() process_scheduled_works() pdr_locator_new_server() pdr->locator_init_complete=true; pdr_locator_work() mutex_lock(&pdr->list_lock); pdr_locate_service() mutex_lock(&pdr->list_lock); pdr_get_domain_list() pr_err("PDR: %s get domain list txn wait failed: %d\n", req->service_name, ret); Timeout error log due to deadlock: " PDR: tms/servreg get domain list txn wait failed: -110 PDR: service lookup for msm/adsp/sensor_pd:tms/servreg failed: -110 " Thanks to Bjorn and Johan for letting me know that this commit also fixes an audio regression when using the in-kernel pd-mapper as that makes it easier to hit this race. | 5.5 |