Vulnerabilities > Linux > Linux Kernel > 5.15.43
| DATE | CVE | VULNERABILITY TITLE | RISK |
|---|---|---|---|
| 2024-07-16 | CVE-2022-48788 | Use After Free vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: nvme-rdma: fix possible use-after-free in transport error_recovery work While nvme_rdma_submit_async_event_work is checking the ctrl and queue state before preparing the AER command and scheduling io_work, in order to fully prevent a race where this check is not reliable the error recovery work must flush async_event_work before continuing to destroy the admin queue after setting the ctrl state to RESETTING such that there is no race .submit_async_event and the error recovery handler itself changing the ctrl state. | 7.8 |
| 2024-07-16 | CVE-2022-48808 | Unspecified vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: net: dsa: fix panic when DSA master device unbinds on shutdown Rafael reports that on a system with LX2160A and Marvell DSA switches, if a reboot occurs while the DSA master (dpaa2-eth) is up, the following panic can be seen: systemd-shutdown[1]: Rebooting. Unable to handle kernel paging request at virtual address 00a0000800000041 [00a0000800000041] address between user and kernel address ranges Internal error: Oops: 96000004 [#1] PREEMPT SMP CPU: 6 PID: 1 Comm: systemd-shutdow Not tainted 5.16.5-00042-g8f5585009b24 #32 pc : dsa_slave_netdevice_event+0x130/0x3e4 lr : raw_notifier_call_chain+0x50/0x6c Call trace: dsa_slave_netdevice_event+0x130/0x3e4 raw_notifier_call_chain+0x50/0x6c call_netdevice_notifiers_info+0x54/0xa0 __dev_close_many+0x50/0x130 dev_close_many+0x84/0x120 unregister_netdevice_many+0x130/0x710 unregister_netdevice_queue+0x8c/0xd0 unregister_netdev+0x20/0x30 dpaa2_eth_remove+0x68/0x190 fsl_mc_driver_remove+0x20/0x5c __device_release_driver+0x21c/0x220 device_release_driver_internal+0xac/0xb0 device_links_unbind_consumers+0xd4/0x100 __device_release_driver+0x94/0x220 device_release_driver+0x28/0x40 bus_remove_device+0x118/0x124 device_del+0x174/0x420 fsl_mc_device_remove+0x24/0x40 __fsl_mc_device_remove+0xc/0x20 device_for_each_child+0x58/0xa0 dprc_remove+0x90/0xb0 fsl_mc_driver_remove+0x20/0x5c __device_release_driver+0x21c/0x220 device_release_driver+0x28/0x40 bus_remove_device+0x118/0x124 device_del+0x174/0x420 fsl_mc_bus_remove+0x80/0x100 fsl_mc_bus_shutdown+0xc/0x1c platform_shutdown+0x20/0x30 device_shutdown+0x154/0x330 __do_sys_reboot+0x1cc/0x250 __arm64_sys_reboot+0x20/0x30 invoke_syscall.constprop.0+0x4c/0xe0 do_el0_svc+0x4c/0x150 el0_svc+0x24/0xb0 el0t_64_sync_handler+0xa8/0xb0 el0t_64_sync+0x178/0x17c It can be seen from the stack trace that the problem is that the deregistration of the master causes a dev_close(), which gets notified as NETDEV_GOING_DOWN to dsa_slave_netdevice_event(). But dsa_switch_shutdown() has already run, and this has unregistered the DSA slave interfaces, and yet, the NETDEV_GOING_DOWN handler attempts to call dev_close_many() on those slave interfaces, leading to the problem. The previous attempt to avoid the NETDEV_GOING_DOWN on the master after dsa_switch_shutdown() was called seems improper. | 5.5 |
| 2024-07-15 | CVE-2024-41007 | Unspecified vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: tcp: avoid too many retransmit packets If a TCP socket is using TCP_USER_TIMEOUT, and the other peer retracted its window to zero, tcp_retransmit_timer() can retransmit a packet every two jiffies (2 ms for HZ=1000), for about 4 minutes after TCP_USER_TIMEOUT has 'expired'. The fix is to make sure tcp_rtx_probe0_timed_out() takes icsk->icsk_user_timeout into account. Before blamed commit, the socket would not timeout after icsk->icsk_user_timeout, but would use standard exponential backoff for the retransmits. Also worth noting that before commit e89688e3e978 ("net: tcp: fix unexcepted socket die when snd_wnd is 0"), the issue would last 2 minutes instead of 4. | 3.3 |
| 2024-07-14 | CVE-2023-52885 | Use After Free vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: SUNRPC: Fix UAF in svc_tcp_listen_data_ready() After the listener svc_sock is freed, and before invoking svc_tcp_accept() for the established child sock, there is a window that the newsock retaining a freed listener svc_sock in sk_user_data which cloning from parent. | 7.8 |
| 2024-07-12 | CVE-2024-39494 | Use After Free vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: ima: Fix use-after-free on a dentry's dname.name ->d_name.name can change on rename and the earlier value can be freed; there are conditions sufficient to stabilize it (->d_lock on dentry, ->d_lock on its parent, ->i_rwsem exclusive on the parent's inode, rename_lock), but none of those are met at any of the sites. | 7.8 |
| 2024-07-12 | CVE-2024-39495 | Use After Free vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: greybus: Fix use-after-free bug in gb_interface_release due to race condition. In gb_interface_create, &intf->mode_switch_completion is bound with gb_interface_mode_switch_work. | 7.8 |
| 2024-07-12 | CVE-2024-39496 | Use After Free vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: btrfs: zoned: fix use-after-free due to race with dev replace While loading a zone's info during creation of a block group, we can race with a device replace operation and then trigger a use-after-free on the device that was just replaced (source device of the replace operation). This happens because at btrfs_load_zone_info() we extract a device from the chunk map into a local variable and then use the device while not under the protection of the device replace rwsem. | 7.8 |
| 2024-07-12 | CVE-2024-39506 | NULL Pointer Dereference vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: liquidio: Adjust a NULL pointer handling path in lio_vf_rep_copy_packet In lio_vf_rep_copy_packet() pg_info->page is compared to a NULL value, but then it is unconditionally passed to skb_add_rx_frag() which looks strange and could lead to null pointer dereference. lio_vf_rep_copy_packet() call trace looks like: octeon_droq_process_packets octeon_droq_fast_process_packets octeon_droq_dispatch_pkt octeon_create_recv_info ...search in the dispatch_list... ->disp_fn(rdisp->rinfo, ...) lio_vf_rep_pkt_recv(struct octeon_recv_info *recv_info, ...) In this path there is no code which sets pg_info->page to NULL. So this check looks unneeded and doesn't solve potential problem. But I guess the author had reason to add a check and I have no such card and can't do real test. In addition, the code in the function liquidio_push_packet() in liquidio/lio_core.c does exactly the same. Based on this, I consider the most acceptable compromise solution to adjust this issue by moving skb_add_rx_frag() into conditional scope. Found by Linux Verification Center (linuxtesting.org) with SVACE. | 5.5 |
| 2024-07-12 | CVE-2024-40902 | Classic Buffer Overflow vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: jfs: xattr: fix buffer overflow for invalid xattr When an xattr size is not what is expected, it is printed out to the kernel log in hex format as a form of debugging. | 7.8 |
| 2024-07-12 | CVE-2024-40904 | Unspecified vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: USB: class: cdc-wdm: Fix CPU lockup caused by excessive log messages The syzbot fuzzer found that the interrupt-URB completion callback in the cdc-wdm driver was taking too long, and the driver's immediate resubmission of interrupt URBs with -EPROTO status combined with the dummy-hcd emulation to cause a CPU lockup: cdc_wdm 1-1:1.0: nonzero urb status received: -71 cdc_wdm 1-1:1.0: wdm_int_callback - 0 bytes watchdog: BUG: soft lockup - CPU#0 stuck for 26s! [syz-executor782:6625] CPU#0 Utilization every 4s during lockup: #1: 98% system, 0% softirq, 3% hardirq, 0% idle #2: 98% system, 0% softirq, 3% hardirq, 0% idle #3: 98% system, 0% softirq, 3% hardirq, 0% idle #4: 98% system, 0% softirq, 3% hardirq, 0% idle #5: 98% system, 1% softirq, 3% hardirq, 0% idle Modules linked in: irq event stamp: 73096 hardirqs last enabled at (73095): [<ffff80008037bc00>] console_emit_next_record kernel/printk/printk.c:2935 [inline] hardirqs last enabled at (73095): [<ffff80008037bc00>] console_flush_all+0x650/0xb74 kernel/printk/printk.c:2994 hardirqs last disabled at (73096): [<ffff80008af10b00>] __el1_irq arch/arm64/kernel/entry-common.c:533 [inline] hardirqs last disabled at (73096): [<ffff80008af10b00>] el1_interrupt+0x24/0x68 arch/arm64/kernel/entry-common.c:551 softirqs last enabled at (73048): [<ffff8000801ea530>] softirq_handle_end kernel/softirq.c:400 [inline] softirqs last enabled at (73048): [<ffff8000801ea530>] handle_softirqs+0xa60/0xc34 kernel/softirq.c:582 softirqs last disabled at (73043): [<ffff800080020de8>] __do_softirq+0x14/0x20 kernel/softirq.c:588 CPU: 0 PID: 6625 Comm: syz-executor782 Tainted: G W 6.10.0-rc2-syzkaller-g8867bbd4a056 #0 Hardware name: Google Google Compute Engine/Google Compute Engine, BIOS Google 04/02/2024 Testing showed that the problem did not occur if the two error messages -- the first two lines above -- were removed; apparently adding material to the kernel log takes a surprisingly large amount of time. In any case, the best approach for preventing these lockups and to avoid spamming the log with thousands of error messages per second is to ratelimit the two dev_err() calls. | 5.5 |