Vulnerabilities > Linux > Linux Kernel > 5.15.20
| DATE | CVE | VULNERABILITY TITLE | RISK |
|---|---|---|---|
| 2024-06-19 | CVE-2024-38588 | Use After Free vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: ftrace: Fix possible use-after-free issue in ftrace_location() KASAN reports a bug: BUG: KASAN: use-after-free in ftrace_location+0x90/0x120 Read of size 8 at addr ffff888141d40010 by task insmod/424 CPU: 8 PID: 424 Comm: insmod Tainted: G W 6.9.0-rc2+ [...] Call Trace: <TASK> dump_stack_lvl+0x68/0xa0 print_report+0xcf/0x610 kasan_report+0xb5/0xe0 ftrace_location+0x90/0x120 register_kprobe+0x14b/0xa40 kprobe_init+0x2d/0xff0 [kprobe_example] do_one_initcall+0x8f/0x2d0 do_init_module+0x13a/0x3c0 load_module+0x3082/0x33d0 init_module_from_file+0xd2/0x130 __x64_sys_finit_module+0x306/0x440 do_syscall_64+0x68/0x140 entry_SYSCALL_64_after_hwframe+0x71/0x79 The root cause is that, in lookup_rec(), ftrace record of some address is being searched in ftrace pages of some module, but those ftrace pages at the same time is being freed in ftrace_release_mod() as the corresponding module is being deleted: CPU1 | CPU2 register_kprobes() { | delete_module() { check_kprobe_address_safe() { | arch_check_ftrace_location() { | ftrace_location() { | lookup_rec() // USE! | ftrace_release_mod() // Free! To fix this issue: 1. | 7.8 |
| 2024-06-19 | CVE-2024-38590 | Unspecified vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: RDMA/hns: Modify the print level of CQE error Too much print may lead to a panic in kernel. | 5.5 |
| 2024-06-19 | CVE-2024-38591 | Improper Locking vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: RDMA/hns: Fix deadlock on SRQ async events. xa_lock for SRQ table may be required in AEQ. | 5.5 |
| 2024-06-19 | CVE-2024-38597 | Improper Locking vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: eth: sungem: remove .ndo_poll_controller to avoid deadlocks Erhard reports netpoll warnings from sungem: netpoll_send_skb_on_dev(): eth0 enabled interrupts in poll (gem_start_xmit+0x0/0x398) WARNING: CPU: 1 PID: 1 at net/core/netpoll.c:370 netpoll_send_skb+0x1fc/0x20c gem_poll_controller() disables interrupts, which may sleep. We can't sleep in netpoll, it has interrupts disabled completely. Strangely, gem_poll_controller() doesn't even poll the completions, and instead acts as if an interrupt has fired so it just schedules NAPI and exits. | 5.5 |
| 2024-06-19 | CVE-2024-38600 | Improper Locking vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: ALSA: Fix deadlocks with kctl removals at disconnection In snd_card_disconnect(), we set card->shutdown flag at the beginning, call callbacks and do sync for card->power_ref_sleep waiters at the end. | 5.5 |
| 2024-06-19 | CVE-2024-38608 | NULL Pointer Dereference vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: net/mlx5e: Fix netif state handling mlx5e_suspend cleans resources only if netif_device_present() returns true. | 5.5 |
| 2024-06-19 | CVE-2024-36978 | Out-of-bounds Write vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: net: sched: sch_multiq: fix possible OOB write in multiq_tune() q->bands will be assigned to qopt->bands to execute subsequent code logic after kmalloc. | 7.8 |
| 2024-06-10 | CVE-2024-36971 | Use After Free vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: net: fix __dst_negative_advice() race __dst_negative_advice() does not enforce proper RCU rules when sk->dst_cache must be cleared, leading to possible UAF. RCU rules are that we must first clear sk->sk_dst_cache, then call dst_release(old_dst). Note that sk_dst_reset(sk) is implementing this protocol correctly, while __dst_negative_advice() uses the wrong order. Given that ip6_negative_advice() has special logic against RTF_CACHE, this means each of the three ->negative_advice() existing methods must perform the sk_dst_reset() themselves. Note the check against NULL dst is centralized in __dst_negative_advice(), there is no need to duplicate it in various callbacks. Many thanks to Clement Lecigne for tracking this issue. This old bug became visible after the blamed commit, using UDP sockets. | 7.8 |
| 2024-06-08 | CVE-2024-36965 | Unspecified vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: remoteproc: mediatek: Make sure IPI buffer fits in L2TCM The IPI buffer location is read from the firmware that we load to the System Companion Processor, and it's not granted that both the SRAM (L2TCM) size that is defined in the devicetree node is large enough for that, and while this is especially true for multi-core SCP, it's still useful to check on single-core variants as well. Failing to perform this check may make this driver perform R/W operations out of the L2TCM boundary, resulting (at best) in a kernel panic. To fix that, check that the IPI buffer fits, otherwise return a failure and refuse to boot the relevant SCP core (or the SCP at all, if this is single core). | 5.5 |
| 2024-06-08 | CVE-2024-36967 | Memory Leak vulnerability in Linux Kernel In the Linux kernel, the following vulnerability has been resolved: KEYS: trusted: Fix memory leak in tpm2_key_encode() 'scratch' is never freed. | 5.5 |